28
28
8. In similar manner attach the guard (C) by pressing
and holding the quick-release button (B) and
inserting the lock pin of the guard into the
appropriate slot (G) on the riving knife.
9. You should feel a snap as each piece locks in
position. Attempt to lift as a test to make sure that
they are securely locked in place.
Adjustment
1. The clamping blocks (L and M) are adjusted at the
factory and no further adjustment of the blade
guard and riving knife assembly should be
necessary. However, proper alignment is very
important. Before operating the table saw, verify,
and follow the Riving Knife adjustment procedure if
necessary.
Riving Knife Adjustment
Lateral alignment
The saw blade and riving knife must be in line as close
as possible with each other (lateral alignment) for the
prevention of kickback. Alignment should be checked
and adjusted, if required, after each blade change.
Check the alignment as follows:
1. Remove the blade guard and pawl (C and E).
2. Place a straightedge (A) on the table so it rests
against the blade (B) and riving knife (C).
3. Rotate the blade so the top of the blade tooth
touches the straightedge.
4. The saw blade and riving knife must be in line.
e
Riving Knife Thickness
b
Saw Blade Thickness
B
Blade Kerf (width of saw blade cut)
