47
47
TABLE ROLLERS ADJUSTMENT
The table rollers come pre-set from the factory and s
houldn’t need any adjustment. If you find
adjustment is necessary, follow the below listed steps.
1. Lay a straight edge (A, Fig 23) on the table
across the roller (B, Fig 23).
2. Raise the rollers until it contacts the straight
edge and lock the handle.
3. The pointer should be set at
“0”. If not adjust
the pointer to read zero.
Note:
Spin the roller by hand to know
when roller makes contact with the straight edge.
4. Move straight edge to the opposite side of bed
roller and check to see that the roller just
contacts straight edge.
5. If not loosen the hex nut (C, Fig 24) and turn
the hex cap bolt (D, Fig 24) to raise or lower
the bed roller until it just contacts the straight
edge.
Summary of Contents for IP-2509-HD-3
