Baileigh Industrial IP-2509-HD-3, Operator'S Manual

Page: 48 / 80

45
45
V-BELT ADJUSTMENT
Three V-belts (A, Fig 21) drive the cutterhead.
Belt tension has been set at the factory. If the
belts have stretched and need adjustment.
1. Disconnect machine from power source.
2. Open lower rear, and lower left-hand side
panels.
3. Loosen and tighten four adjustment nuts (C,
Fig 21) to move motor plate up, or down to
increase, or decrease belt tension.
4. Tighten nuts against motor plate after
adjustment is made.
5. Belts are tensioned properly when
moderate finger pressure can deflect the v-
belts about a 1/4"-1/
2” midway between the
pulleys.
TABLE GIBS ADJUSTMENT
1. Adjust gibs (D, Fig 22) by loosening the hex
nuts (E, Fig 22), and turning gib screws (F, Fig
22) so that the ways (G, Fig 22) are lightly
contacted.
2. You should be able to get a 0.
005” feeler
gauge in between the gib and way.
Figure 21
C
A