Baileigh Industrial B8090, Operator'S Manual

Page: 21 / 63

18
18
Edit a Program
1. Select this feature when you want to edit an existing program.
a. From the Program selector screen Fig 5, choose the program number to be edited.
Use the up and down arrows to move the screen up or down one line or one page at a
time. Dashed lines in the name indicate that no program is saved to that location.
b. After selecting the program line. Touch the EDIT button (Fig 5) and the program
parameters will be displayed Fig 6. Press the View button at the top of the screen to
change to the Edit mode.
c. Verify that the bend to be edited is selected. Press the box for the parameter to be
changed and the digit key pad will open. Enter the desired numbers. Add zeros as
needed to move the decimal position.
d. When the changes have been completed, press the System button (Fig. 6) below the
Save box. If this is a new program, the alpha key pad (Fig. 2and 3) will open to allow
the program to be named and saved.
2. After selecting the program touch the RUN button
(Fig 5) and the program parameters will be
displayed Fig 7.
3. At this point, the display reads “Press FWD Pedal
to Bend”. Pressing the forward foot pedal will start
the bending process. The machine will rotate in
the selected direction at the chosen speed to the
desired degree totaling the bend angle plus the
spring back degrees.
4. When at the final position, the control will prompt
you to “Press REV Pedal to Home”.
Delete Program
1. Follow the above steps to get to the edit screen
Fig 6. Press and hold the F3 button below the
CLEAR PROGRAM box to erase all of the bend data for the selected program.
Creating a Program
1. Choose "RUN, VIEW OR EDIT A PROGRAM" from the RMD MAIN SCREEN Fig 1.
2. Select an open program number from 1 to 170 Fig 5. If all of the program numbers have
been filled, then an existing file will need to be overwritten to the new program parameters.
3. When the desired program slot has been selected, press, EDIT Fig 5.
OP Screen Figure 7