Baileigh Industrial B8090, Operator'S Manual

Page: 35 / 63

32
32
6. With the counter die tight, document the number
displayed on the Leadscrew counter, you will want to
return to the same exact number every time to ensure
exact counter die positioning and repeatable bends. This
number can be entered in the control for programmed
bends.
Leadscrew counter, document this position in the controller.
7. Be sure there are no obstructions along the draw side of
the material.
8. Be sure to leave enough material past the plastic slide to
produce the desired bend.
Left Right
•
The left figure shows the recommended minimum / correct amount of material remaining to
be fully supported in plastic slide.
• The right figure shows the maximum amount the material can be pulled through the
counterdie. Pulling the material further than shown into the counter die, it will destroy the
plastic slide.