BAFANG BT C01.340.UART, Manual

Page: 34 / 48

34 CUSTOMER MANUAL FRONT HUB MOTOR SYSTEM
⑹ “SOC View” --- set indication mode for
battery capacity
Briefly press ( < 0.5S) or to selcet “SOC
View”, and then briefly press (<0.5S) .
This moment, briefly press (<0.5S) or
to switch display mode for output as
“Percent”/“Voltage”. After confirmation,
briefly press (<0.5S)
to save the set and
exit back to “SOC View”. Briefly press
for two times (interval time is less than 0.5S)
to exit back to the main interface, or select
“BACK”
→
“EXIT” to exit back to the main
menu.
⑺ “TRIP Reset” --- set reset function for
single-trip distance
Briefly press (<0.5S) or to select “TRIP
Reset”,and then briefly press (<0.5S) .
This moment, briefly press (<0.5S) or
to switch between “NO”and“YES”. TRIP Re-
set includes maximum speed (MAXS), aver-
age speed (AVG), single-trip distance (TRIP).
After confirmation, briefly press (<0.5S)
again to save the set and exit back to the
“TRIP Reset”. Briefly press
for two times
(interval time is less than 0.5S) to exit the
main interface, or select “BACK”
→
“EXIT”
to exit back to the main interface. The data
is not reset automatically when turn off the
display or turn off the power of the bicycle.
⑻ “AL Sensitivity” --- set light sensitivity
Briefly press (<0.5S) or to select “AL
Sensitivity”, and then briefly press (<0.5S)
. This moment, briefly press (<0.5S)
or to switch level of the light sensitivity
between “0”/“1”/“2”/“3”/“4”/“5”/“OFF”.
“OFF” means close the function. Level 1 is
the weakest light sensitivity and level 5 is
the strongest light sensitivity. Select the level
desired and briefly press (<0.5S)
again to
save the setting and exit back to “AL Sensi-
tivity”. Briefly press
for two times (interval
time is less than 0.5S) to exit back to main
interface or select “BACK”
→
“EXIT” to exit
back to main interface.
⑼ “Password”--- access password setting
Briefly press ( < 0.5S) or to select
“Password” and then briefly press (<0.5S)
. This momen, briefly press (<0.5S)
or
to select “Start PassWord” and then briefly
press (<0.5S)
again. Briefly press (<0.5S)
or to switch between “OFF”/“ON”, the
below is the specific way of switching.
Starting password:
Enter into “Start PassWord” interface and
select “ON”. Briefly press (<0.5S)
, and
then it show input password in the interface.
This moment, briefly press (<0.5S)
or
to switch numbers “0-9”, and then briefly
press (<0.5S)
to confirm input number.
After input, it show input password again
in the interface. Repeat the above step to
input password again. If the password is
same with the previous time, the system
will prompt it is successful to set password,
otherwise it need to repeat the first step
to input the new password and then re-
confirm.