14
CUSTOMER MANUAL
FRONT HUB MOTOR SYSTEM
5 OPERATION
5.1 Installing the battery
For correct insertion, the battery must be
inserted and locked from the rear of the casing
as far as it will go. Without contact with the
battery, the electric drive of your pedelec will
not work.
1. If your battery has an on/off switch, always
turn off the battery before inserting it into
the holder.
2. For the battery to be inserted, the lock must
be unlocked. You can lock and unlock the
battery by turning the key provided.
3. Slide the battery along the rail track into the
connector on the rail as far as it will go, then
turn the key to lock the battery.
4. Remove the key to avoid losing or breaking it.
5.2 Removing the battery
When removing the battery, proceed as follows:
1. Switch off the electric drive system and, if
possible, the battery.
2. Unlock the battery.
Pull out of rack
3. Remove the battery from the casing/battery
holder.
Hold the battery tightly as it is heavy.
5.3 LED capacity and state
of charge indication
•
Press the button to wake up from Sleep
mode
•
Hold down the button for 5 seconds to
wake up from deep Sleep mode
Then check the current charge level of your bat-
tery by pressing the on / off button of the battery.
The charge status is indicated by LEds, which are
illuminated for different charging states as listed
in the following table.
