Page 13
For technical questions, please call 1-888-866-5797.
Item 61876
SAFET
y
Op
ERA
TION
MAINTENANCE
SETU
p
Troubleshooting
problem
possible Causes
Likely Solutions
Motor overheats.
1. Incorrect power cords.
2. Winch running time too long.
1. Use only supplied power cords.
2. Allow Winch to cool down periodically.
Motor does
not turn on.
1. Switch not connected properly.
2. Loose battery cable connections.
3. Vehicle battery needs charging.
4. Defective Switch.
5. Defective motor.
6. Water has entered motor.
7. Internal damage or wear.
1. Connect Switch properly.
2. Tighten nuts on all cable connections.
3. Fully charge battery.
4. Replace Switch.
5. Check for voltage at armature port
with Switch pressed. If voltage
is present, replace motor.
6. Allow to drain and dry. Run in short
bursts without load until completely dry.
7. Have technician service Winch.
Motor runs
slowly or without
normal power.
1. Insufficient current or voltage.
2. Loose or corroded battery
cable connections.
3. Incorrect power cords.
1. Battery weak, recharge.
Run Winch with vehicle motor running.
2. Clean, tighten, or replace.
3. Use only supplied power cords.
Follow all safety precautions whenever diagnosing or servicing
the tool. Disconnect power supply before service.
Summary of Contents for 61876
Page 1: ......
