GENERAL DESCRIPTION
The Model 2100 is an ultrasonic level transmitter
designed to measure fluid flows through open channel
primary devices or fluid level. The meter is equipped with
a 2-line, 24 character per line LCD display, 4-20 mADC
signal output, 4 programmable relays and a RS232 serial
communications port.
The Model 2100 is microprocessor based and is fully
programmable by the front panel keypad. The meter has
the power functions stored in memory for the most
commonly used flumes and weirs. For primary devices
not stored in the meter, a 16 point curve can be
programmed into the meter. There are five keys that are
used to access meter status information or to program the
meter. These keys are the MENU, ENTER, UP arrow,
DOWN arrow and RIGHT arrow.
The MENU key allows access to the Status Mode or
Calibration Mode of the meter. It also can be used to
return to normal operation any time you are in the Status
or Calibration Mode. If you press the MENU key while in
the Calibration Mode, the processor will store any
programming changes made up to that point but will
retain the previous programming after that point.
The ENTER key is used to store any data changes that
are made in the Calibration Mode and advance the
screens in the Status Mode.
The UP, DOWN, and RIGHT arrow keys are used for
selecting or making change sin the various screens of the
meter Calibration Mode.
To prevent unauthorized entry into the Calibration Mode of the
Meter, there is a security screen that requires the correct security
code to be entered in order to gain access.
When power is first applied, the display will have a
solid line across the top of the display for a few seconds.
Then the following screen will appear:
FLOW 1234 X 10 GPM
12345678 X 1000 GAL
Badger Meter
Compu-Sonic
MODEL 2100
OPERATION
MODEL 2100
SOFTWARE REV. - X.XX
This will be displayed for about 3 seconds and then the
next screen will show the serial number of the unit as
shown below:
- BADGER METER -
SERIAL NUMBER XXXXXXXX
This will be displayed for about 3 seconds and then one
of the next three screens will be displayed depending on
whether your unit has been programmed for flow and
totalization, flow only or level only measurement.
- FLOW 1234 X 10 GPM
12345678 X 100 GAL
OR
- FLOW 1234 X 10 GPM
FLUID LEVEL = 99.99 IN
OR
- BADGER METER -
FLUID LEVEL = 12.3 IN.
These three screens are considered the normal
operating screens. In the upper left corner of the display
there will be either a flashing '-' or '*'. The '-' indicates
that the meter is functioning properly and that there are no
alarms or relays tripped. The '*' indicates that there are
alarms or relays tripped.
3-1