FUNCTIONS
• The device has an operating distance of 300 m in open spaces.
• 2 selectable channels.
• Coded communication between the 2 units ensures private and
protected use withyour baby.
• Visual low battery alarm on transmitter and receiver.
• There is a nightlight on the transmitter. VOX (voice-activated) or
Continuous operation or OFF.
• Volume control on the receiver.
• Voice-activated (VOX) or continuous transmitter.
• Visual reception lever indicator, which displays the signal
strength even when the volume is turned down.
• The transmitter and receiver work from the mains with a 5V
adapter.
POWER SUPPLIES
Transmitter and receiver
Battery operated
Slide down the battery cover. Insert four AAA batteries,
respecting the polarity.
Replace the battery cover (d).
NOTE: For best operation, do not mix used and new batteries, or
alkaline and rechargeable batteries.
USE
Transmitter
1. Place the transmitter’s power ON/OFF switch to ON (2)
for continuous mode or to VOX for voice-triggered operation.
2. The power and low batteries (1) light will appear green. If it is
flashing, this means that they are running low. Replace them
with new alkaline batteries or plug the transmitter into the
power socket.
3. Select channel 1 or 2 from the channel selector (3).
4. Place the transmitter near the child with the microphone (6)
facing the child, but out of his/her reach, preferably at a distance
of approximately 1 meter.
5. As soon as the transmitter picks up the slightest sound from
your child, it will switch on and the transmission indicator light
(4) will appear red.
6. When the baby stops crying, the transmitter goes back to
monitor mode and the transmission indicator light (1) switches
off.
7. Activating the nightlight: Turn the nightlight switch to On (7).
When you select VOX transmission mode, the nightlight will also
operate in VOX mode (it only switches on when it detects the baby’s
voice).
Receiver
1. Switch on the receiver with the switch (10).
2. The power indicator light (8) will appear green. If it is flashing,
this means the batteries are running low. Replace them with
new alkaline batteries or plug the transmitter into the power
socket.
3. Select channel 1 or 2 on the channel selector (11), and make
sure the same channel has been selected on the transmitter.
4. Place the receiver at a reasonable distance from the transmitter
(too close creates audio feedback, producing a larsen effect in
the loud-speaker).
5. When it receives the signal, the transmission indicator lights up
(12). The stronger the voice, the more LED lights come on. This
visual alarm function can be useful when the receiver sound is
minimum.
6. The volume is set with the control (10).
7. To switch from «Vibrate» mode to «Sound» mode, gently turn
the control (10) until you hear a double beep. To return to
«Vibrate» mode, turn the control (10) until you hear the device
vibrate twice.
EN
STANDARD ACCESSORIES
a. Transmitter
b. Receiver
c. 5V adaptater
d. Instructions for use
(a) : B014007SAV601
(b) : B014010SAV600
(c) : B014010SAV500
The a and b spare parts are available with our custumer service
CONTROLS
Transmitters
1. Power indicator light and battery alarm
2. On/Off switch and selection of VOX or continuous mode
3. Choice of channel
4. Transmission indicator light
5. Mains connection socket
6. Microphone
7. Nightlight On/Off switch
Receiver
8. On/off indicator light and battery alarm
9. Loudspeaker
10. On/Off switch volume setting and vibrator
11. Choice of channel
12. Light diodes visual alarm
13. Mains connection plug
7