SECTION 6: CUTTING DECK
PAGE
29
Deck belt removal
1) Remove ignition key.
2) Raise the deck to its highest position.
3) Remove the right pulley cover.
4) While lifting up on the belt (as shown in the
photograph), rotate the pulley until the belt is free of
the pulley. Exercise caution while performing this step
as fingers can easily become caught between the
belt and pulley.
Deck belt installation:
1) Follow steps 1 and 2 from the deck removal
section.
2) Take off both pulley covers and route the belt
by following the belt route sticker.
3) The easiest way to finish running the
belt is routing the belt through the deck
pulleys and carefully slipping the belt
onto the clutch in the rear of the engine.
4) Verify that the belt is routed properly as
improper routing can damage the
spindles as well as the engine.
Summary of Contents for Outlaw Stand-On BBS 3600
Page 27: ...PAGE 27...
Page 53: ...PAGE 53...
