SECTION 4: ELECTRICAL SYSTEM
This mower is equipped with two protective fuses: a 25
amp main fuse (pictured to the right) and a 15 amp clutch
fuse (blade engagement). The main fuse is located on
the
right side of the unit;
towards the rear of the engine.
The clutch fuse is located just underneath the operator’s
console. A blown fuse usually indicates a problem within
the electrical system or an electrical component. Never
replace a fuse with one of a higher amperage rating or
‘bypass’ a fuse in any way. Doing so creates a significant
fire hazard and can cause severe damage to the mower’s
electrical components. If either fuse is repeatedly blowing,
contact your Bad Boy dealer.
Always check the condition of the wiring harness ground
cable. Ensure that the ground is connected, clean, and
tight.
Check the condition and connection of the relays located
on the right wall of the gas tank compartment. Ensure that
they are clean and connected. Make sure that wire terminal
ends have not been pushed out of the relay block.
The red wire coming out of the engine is the charging wire
from the alternator. Check for 13.6—14.2 volts DC at this
wire with engine at full throttle.
PAGE
26
The stand on is equipped with two Hall Effect sensors
and two magnets. The Hall Effect sensor must be lined
up with magnet in order to start. If the mower will not
start check to make sure they are lined up. You will hear
the audible clicking of a relay when you more the sensor
away from the magnet. The magnet can be adjusted in
order to line up with the Hall Effect sensor.
Summary of Contents for Outlaw Stand-On BBS 3600
Page 27: ...PAGE 27...
Page 53: ...PAGE 53...
