Bacci Twin, Use And Maintenance Instruction Manual

Page: 34 / 202

TWIN
– Use and maintenance instruction manual
Chap. 2
-
16
/
52 -
2.5 Envisaged use
Envisaged use means use of the machine in conformity with the information provided in the user
instructions.
The machine may be used only by professional operators who are trained and informed as to the
contents of this instructions manual.
Operators designated to running the machine are responsible for preparing the machine for operation,
starting up the machine and checking and adjusting the work parameters. All operations must be carried
out in accordance with the commands and work procedures described in the instruction manual.
The machine is designed to machine pieces made of wood or other similar materials, the characteristics
of which are defined in the technical data.
The machine is provided with 2 work stations, one in front of the control panel and another in front of the
loaders, where the operator may stand during the work cycle.
The machine may be used by only one operator at a time; simultaneous use by two or more operators is
forbidden.
Recipe settings and parameters are set using the HMI device installed on the electrical control panel.
Access to hazard areas for any task required for machine operation are limited by safety requirement
conditions; access to these areas must be carried out in conformity with the instructions provided in this
manual and in all annexed documents.
The machine is designed and manufactured to mill, drill and cut woody materials, materials deriving from
wood or other similar materials
(1)
. The machine may not be used to process other kinds of materials;
uses different from that envisaged may damage the machine and constitute a hazard for operators.
To avoid possible, improper use, we recommend taking into consideration the consistency of the
material and rapport it to the spindle motor being used. Furthermore, do not use the machine to process
pieces that do not fit into the maximum work strokes specified in the section “Technical and ambient
data”.
NOTE (1): similar materials: materials with machining parameters for milling, drilling and cutting that are
comparable to the machining parameters for woody materials (for example: ureic resin, PVC, ...)