Copyright © 2007 - 2009, Baby Trend Inc., All Rights Reserved.
Copyright © 2007 - 2009, Baby Trend Inc., All Rights Reserved.
7
8
SAFETY
• Carefully place the child in the stroller seat
and bring the safety harness around the
child's waist and over the shoulders. Place the
crotch strap between the child's legs. Insert
the male end of each shoulder/waist belt into
the buckle on the crotch strap. Tighten the
harness to be snug around the child's waist
and over the child's shoulders Please see
figure 17.
• To release, apply pressure to both sides of
each male clip until the clip is released. See
figure 18. This process requires a moderate
amount of effort so as to prevent an accidental
release by your child.
WARNING:
The upright
position should be used only for a
child that is at least 6 months old.
SEAT BACK POSITION
The seat has a multiple position recline that is
controlled by a cord and spring loaded adjuster
behind the seat. To recline the seat, pull back on
the loop of the adjuster. (Fig.19) To place the seat
back in a more upright position, grab the adjuster
with one hand and pull the cord to the desired
position with the other hand. (Fig. 20) The cord
will lock automatically.
WARNING:
Never use
seat in a reclined carriage position
unless enclosure is raised to cover
the front opening. Child may slip
into leg openings and strangle.
FULL RECLINE/CARRIAGE
POSITION
(if equipped)
To recline the seat, pull back on the loop of the
adjuster. (Fig. 20) Fold up foot rest and secure
with velcro straps through slots on sides. (Fig. 21)
INFANT CAR SEAT
WARNING:
Failure to
follow these car seat attachment
instructions could result in serious
injury or death.
INFANT CAR SEAT ATTACHMENT
To attach the Baby Trend Infant Car Seat, recline
the seat all the way back. (Fig. 22)
• Position the Infant Car Seat, facing toward the
rear of the stroller, so that the seat shell goes
into the front tray and latches into place. (Fig.
23)
Check that the Infant Car Seat is firmly
locked onto the front tray before using
.
•
Check that the front child tray is firmly
attached to the stroller armrests
. Make sure
that the car seat locks into the front child tray.
Then turn tabs on stroller frame to lock the
front of the car seat into the stroller. (Fig. 24)
• To remove the Infant Car Seat, squeeze the
release handle located at the foot-end of the
seat and carefully lift upward on the seat.
(Fig. 25)
Fig. 17
Shoulder Strap
Squeeze
Adjust for a snug fit
Crotch Strap
Waist Strap
Fig. 18
Fig. 19
Fig. 20
Fig. 21
Fig. 22
Fig. 23
Locks
into tray
Fig. 24
Fig. 25
