Copyright © 2007 - 2009, Baby Trend Inc., All Rights Reserved.
Copyright © 2007 - 2009, Baby Trend Inc., All Rights Reserved.
IMPORTANT!
To ensure safe operation of your stroller,
please follow these instructions carefully. Please keep these
instructions for future reference.
IMPORTANT!
Before assembly and each use, inspect this
product for damaged hardware, loose joints, missing parts or sharp
edges. NEVER use if any parts are mssing or broken.
IMPORTANT!
Adult assembly is required.
ASSEMBLY
Remove stroller from box. The front wheels,
rear wheels, child tray, and parent tray
MUST
be
installed prior to use.
FRONT WHEELS
To attach the front wheels, unfold stroller as
described in the section following:
• Unfold stroller frame by sliding the
RED
thumb trigger to the left and squeezing the
RED
pull trigger (Fig. 1) while pulling
backward on the stroller handle. (Fig. 2)
To attach the front wheels, lean the stroller back
so that it rests on the handle with the front and
rear legs pointing upward. Position the front
wheels over the front leg tubes so that the hole in
the housing lines up and will slide onto the legs.
(Fig. 3) Firmly push down until the wheels lock
securely into place. Tug on each wheel to ensure
they are both securely attached.
REAR WHEELS
Attach the rear axle assembly and wheels as
follows:
• Position axle assembly over the rear leg tubes,
brake pedals facing the back. At the same
time, push down applying equal pressure to
both sides until they lock into place. (Fig. 4)
3
4
Note:
NEVER
use stroller if wheels do not lock into
place. If you need assistance, please contact our
customer service department at 1-800-328-7363,
M-F, between 8am and 4:30pm, PST.
CHILD TRAY
To attach the child tray:
push the angled side
of the tray onto the post at the end of the right
armrest while pressing downward on the snap
button, until locking in place. (Fig. 5) Rotate the
tray downward until it latches onto the left armrest
into place. (Fig. 6)
Note: Check that the snap button comes through
and securely in place. (Fig. 7)
To remove the child tray:
You can remove the
tray completely by pressing the snap button on
the right side and pulling forward on the tray until
released. (Fig.8)
PARENT TRAY
To attach parent tray, line up the parent tray slots
with corresponding slots on the stroller frame
and slide down until locking into place. (Fig. 9)
Check to make sure the parent tray is secure
before using.
WARNING:
Do not place
hot liquids or more than 3 pounds
in the parent tray. Serious burns or
unstable conditions could result.
ASSEMBLY
Fig. 4
Fig. 3
Fig. 1
Fig. 2
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9
