ASSEMBLY
ASSEMBLY
15
16
Copyright © 2019, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Copyright © 2019, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Fig. 19b
Fig. 19a
Fig. 20a
Fig. 20b
TO USE CHANGING TABLE
RESTRAINT SYSTEM
19)
• Place child on changing table, make sure
hand and arms are clear of the restraint.
Bring the restraint around the child’s waist
and clip the male and female ends of the
buckle together (Fig. 19a).
• Tighten strap until it fits snug around
child’s waist (Fig. 19b).
DO NOT OVER TIGHTEN.
• To remove, unsnap the buckle.
ATTENTION: NEVER
use changing table
if it is damaged or broken.
TO REMOVE CHANGING TABLE
20)
• Flip Changing Table to the outside of the
Playard. Unsnap fabric flap of Changing
Table from Playard. Twist Connector
Knobs clockwise to unlock (Fig. 20a).
Remove Changing Table from Playard
(Fig. 20b) and disconnect the Short Bars
from the Curved Bar by pressing on the
snap buttons and pulling apart. Remove
Curved Bar from Changing Table sleeve.
Fig. 21b
Fig. 21a
Diaper Stacker
Fig. 21b
Parent Organizer
Hook Face Out
PARENT ORGANIZER ASSEMBLY
or
Parent
Organizer
Diaper
Stacker
21)
• Parent Organizer: Position each hook
so that the hooked end is facing the rear
side of the organizer. Press the hook
down firmly into the slot until it locks into
place (Fig. 21a). Diaper Stacker: Skip to
next step.
• Connect the Parent Organizer/Diaper
Stacker to the Playard by sliding the two
connecting clips over an open portion of
the top rail of the Playard (Fig. 21b).
NOTE:
The Parent Organizer/Diaper
Stacker can only be installed on
open sides of the Playard where the
connecting clips can easily be attached
without interfering with other features.
