Your Rock arrives flat packed and complete. It requires no
frame assembly. Remove all parts of the Rocker from the
carton and packaging.
Dispose of any packaging thoughtfully and responsibly.
ROCK CONTENTS
Opening The Rock
On the head of the seat, you will find a lever; this is the seat
incline and recline adjuster. Lift this lever, and push the seat
forward to elevate the seat.
To recline, lift the lever and pull the seat down.
To completely flatten the Rock, you need to lower the seat to
the lowest level, and then find the bar with the notches cut out,
and lift to let the seat lay flat.
Warning: always make sure to test the seat, that it is
properly seated at each position.
To allow the Swing & Flat, to rock; there are on the outside of
the flat black base, there are 2 curved runners, these will flip
down and under the frame to
allow the Rocker to rock.
To flip the runners back up to stop it from rocking, there are
sliding locks on the end of the black frame, slide the lock to the
center, and flip the runner up. Repeat for the other side. (see
image)
There are 4 positions for the Rock to be in, a fully upright, 2
recline positions, and one flat (storage position).
On the head of the seat, you will find a lever; this is the seat
incline and recline adjuster. Lift this lever, and push the seat
forward to elevate the seat. To recline, lift the lever and pull
the seat down to the desired position.
To completely flatten the Rock, you need to lower the seat to
the lowest level, and then find the bar with the notches cut out,
and lift to let the seat lay flat.
WARNING: always make sure to test the seat, that it is
properly seated at each position.
HORIZONTAL
LOCKING BAR
English
Summary of Contents for BMSWING
Page 1: ...SWING FLAT BOUNCER...
