![background image](http://html1.mh-extra.com/html/baby-lock/kinetic-frame/kinetic-frame_assembly-instructions-manual_3377574020.webp)
20 Baby Lock Kinetic Frame Assembly Instructions
Parts needed
(1) frame assembly
(1) pole bracket assembly with latches (right)
(1) pole bracket assembly without latches (left)
(4) M8x25 socketed button head cap screw
QF09318-06
(4) M8 flat washer QF09318-09
(4) M8 lock nut QF09318-08
Tools Required
5mm Allen wrench (provided)
17/13mm wrench (provided)
9-1: Slide the left pole bracket assembly down
over the support rail on the left frame side
front. The pole bracket should straddle the
support rail. Attach the pole bracket assembly
using two M8x25mm QF09318-06.
Thread the screws through the center
hole of the pole bracket and the top hole
of the support rail from the outside to the
inside of the frame (Detail 9-1).
Step 9
Pole Bracket Assembly
The Baby Lock Kinetic Quilt Frame pole
brackets have 2 sets of 3 mounting holes to
attach them to the support rails. The center
hole in the 3 holes is normally the optimum
position to install the pole brackets. This hole
normally lines up with the top hole in the
support rails. The support rails have 2 sets of
2 holes for mounting the pole brackets. The
top hole is to be used when using the Baby
Lock
Regalia
standard carriage and the
bottom set of holes is to be used when using
the Pro-Stitcher carriage. The extra 2 holes on
the pole brackets are for adjustment of the pole
brackets, up or down. The pole bracket can be
adjusted 7/16” up or down from the center hole
if needed. On the end of each screw, slide a flat
washer followed by a lock nut, as shown
in Detail 9-1.
9-2: Visually level the pole bracket assembly
and fully tighten the two screws with the 13mm
wrench and 5mm Allen wrench.
9-3: Repeat Steps 9-1 and 9-2 to attach the
right pole bracket assembly, making sure the
ratchet stops are on the inside of the frame.
(Detail 9-2)
Detail 9-1
Use
Top Hole
Use
Center Hole
Detail 9-2
Summary of Contents for Kinetic Frame
Page 1: ......