Baby Lock Ellisimo BLSO, Instruction And Reference Manual

Page: 241 / 364

MAKING EMBROIDERY ADJUSTMENTS
Embr
oi
de
ry
227
5
■
Bobbin Thread is Too Loose
Bobbin thread appears slightly on the right side of
fabric.
a
Right side
b
Wrong side
If this occurs, turn the slotted screw (-) clockwise,
being careful not to over-tighten the screw,
approximately 30-45 degrees to increase bobbin
tension.
■
Bobbin Thread is Too Tight
Upper thread on the right side of fabric seems to be
lifting/looping and bobbin thread is not seen on the
wrong side of fabric.
a
Right side
b
Wrong side
If this occurs, turn the slotted screw (-)
counterclockwise, being careful not to over-loosen
the screw, approximately 30-45 degrees to decrease
bobbin tension.
Using the Automatic Thread
Cutting Function
(END COLOR TRIM)
The automatic thread cutting function will
cut the thread at the end of sewing each color.
This function is initially turned on. To turn this
function off, press key and then . This
function can be turned on or off during
embroidering.
* This setting returns to its default
when the machine is turned off.
a
Press .
b
Press to turn off the automatic thread
cutting function.
o
The key will display as
* When one color thread is sewn, the machine will
stop without cutting the thread.
CAUTION
• When adjusting the alternate bobbin case, be
sure to remove the bobbin from the alternate
bobbin case.
• DO NOT adjust the position of the phillips (+)
screw on the alternate bobbin case as this may
result in damage to the bobbin case, rendering
it unusable.
• If the slotted screw (-) is difficult to turn, do
not use force. Turning the screw too much or
providing force in either (rotational) direction
may cause damage to the bobbin case. Should
damage occur, the bobbin case may not
maintain proper tension.