Switching ON/OFF your Baby Control Digital breathing monitor
(BC-200, BC-210, BC-230)
1. Press and hold the on/off button (1) for 2 seconds. Baby Control Digital breathing monitor will not start by any shorter
pressing.
2. The pre-set threshold level of detection will flash on the display (2) five times. The factory setting is „3“.
3. Then the numerical values - „0” = no movement, „1” to „9” = there is any movement - will repeatedly flash
on the display (2).
4. Baby Control Digital breathing monitor is switched on and ready for operation.
5. The green indicator light (6) flashes when the intensity of movements reaches or exceeds the pre-set threshold level of
detection.
6. The red indicator light (7) will start to flash following a short acoustic signal from the speaker (3), if a dangerous situation
occurs (see Alarm status of Baby Control Digital breathing monitor).
7. After the alarm acoustic signal is activated, you can stop the alarm by pressing the on/off button (1) once. The control
unit (8) is switched off.
8. Baby Control Digital breathing monitor can be switched off by pressing the on/off button (1) twice in succession. After
the first pressing the display (2) shows „-” and if you press the on/off button (1) again within 5 seconds, Baby Control
Digital switches off with two short acoustic signals. If you do not press the on/off button again within 5 seconds, the
monitor stays on and returns to normal operation.
IMPORTANT:
The display of the Baby Control Digital may show values „1“ - „9“ even if there is no movement
or sensor pads are disconnected. This is not an error, the device only adjust the condition most conforming to
the surroundings.
INFORMATION:
When switched off, the device does not consume any electricity, thus it is not necessary to
remove batteries when used daily. In case the device will be out of operation for a longer period of time, take
the alkaline AA batteries out of the battery compartment (5).
Baby Control Digital
7
