babcopark Starke 2127, User Manual

Page: 3 / 57

１ Important Safety Instructions
1.1 Requirements of installation
Generally, parking li
�
s are to be installed with the following condi
�
ons:
1) Supply voltage: 0.9 – 1.1 nominal supply voltage
2) Source frequency: 0.99 – 1.01 nominal frequency
3) Ambient temperature: -10
℃
to +40
℃
4) Rela
�
ve humidity: not exceed 50% at 40
℃
5) Atmosphere: Free from excessive dust, acid fumes, corrosive gases and salt.
6) Avoid exposing to direct sunlight or heat rays which can change the environmental temperature.
7) Avoid exposing to abnormal vibra
�
on.
8) Electrical parts shall withstand the effects of transporta
�
on and storage temperature within a range of
-25
℃
t o 55
℃
and for short periods not exceed 24 hours at up to +70
℃
.
The Pit Lift is designed for cars parking under the stated maximum weight, any other usage is to be considered
improper, thus highly forbidden. Babcopark will not be responsible for any damage or injury resul
�
ng from
neglect or failure of carrying out the requirements in this manual.
The series of pit two post parking li
�
s are designed for indoor use only.
Read this manual carefully before using the machine and follow the instruc
�
ons in this manual to ensure the
parking li
�
with excellent performance and long life
�
me.
1.2 Qualified personnel
1.2.1 The pit parking li
�
should only be installed, operated and maintained by authorized and trained staff,
properly trained for the specific use of the parking li
�
.
1.2.2 The wiring work must comply with local code and be carried out by a cer
�
fied electrician according to
local laws/regula
�
ons.
1.2.3 All adjustments, whether mechanical or electrical, shall only be carried out by authorized persons in
accordance with manufacturer’s instruc
�
ons.
1.3 Notes
1.3.1 The construc
�
on of the founda
�
on pit are to be carried out in accordance with founda
�
on requirements by
the manufacturer and local laws/regula
�
ons before installa
�
on of the parking li
�
.
1.3.2 Read and understand all safety warning procedures before installing and opera
�
ng the parking li
�
.
1.3.3 Keep hands and feet away from any moving parts. Keep feet clear of the parking li
�
when pla
�
orm
lowering.
1.3.4 Make sure there is no one in the vehicle before opera
�
on.
1.3.5 The parking li
�
is only designed to li
�
the en
�
re body of the vehicle with maximum weight not more than
the rated capacity.
1.3.6 Always ensure that safety devices are in good condi
�
on before opera
�
ng the parking li
�
.
1.3.7 It is recommended to back vehicles into the parking li
�
, opposed to forward.
1.3.8 Vehicle shall be parked on the le
�
-right center of the pla
�
orm, with rear
�
res reaching the wheel stopper.
1.3.9 Do not modify the parking li
�
without manufacturer’s permission.
1.3.10 If not to be used anymore, it’s recommended to turn off the power supply, empty the oil tank and dispose
of the fluid properly according to local regula
�
ons.
01
Chapter 1 Safety Instructions