7.3
Positioning the inner container drain plug.
The back of the inner container has two drain holes. The
B9Clean’s drain plug shall be snugly inserted into one of the two
holes before starting the cleaning cycle.
If the height of the part to be cleaned is less than
70 millimeters place the plug in the inner container’s top hole.
If the height of the parts to be cleaned is 70 millimeters or
greater, place the plug in the inner container’s bottom hole.
Part height less than 70 millimeters (mm)
Outer container filled to 1.3 liters
Inner container with drain plug in top hole
Extended build table hanger
7.4
Placing the parts in the inner container
3D printed parts made of cured resin may be cleaned by placing
the parts in the inner container. Parts can be cleaned while still
attached to the Build Table or while resting in the part tray.
If any parts to be cleaned are still attached to the Build Table,
ensure that the hanging arm is secured to the lid and the Build
Table is snugly tightened to the hanging arm. Use the regular
hanging arm if the height of the parts is 70 millimeters or
greater. Use the extended hanging arm if the height of the parts
is less than
70 millimeters.
If any part to be cleaned is not attached to the Build Table, this
part shall rest in the part tray.
If all parts to be cleaned are still attached to the Build Table, the
part tray shall be removed.
Part height 70 millimeters (mm) or greater
Outer container filled to 2.0 liters
Inner container with drain plug in bottom hole
Normal build table hanger
CAUTION
Only 3D printed parts made of cured resin shall be washed in the B9Clean. Cleaning anything that is not
a resin-based, 3D printed part will void the warranty.
Summary of Contents for B9Clean
Page 1: ...USER MANUAL B9Clean...
