B.Pro B.PROTHERM BPT 1020 EUK, Translation Of The Original Operating Instructions, Page: 14 / 48

B.PROTHERM Stainless-Steel, Cooled
– 10 –
Startup
Prerequisites for operation

The unit has reached room temperature and is dry

Unit cleaned

Unit and the power plug have no known defects or visible damage

The locking brakes are locked

If the unit was not transported upright, wait 2 hours before putting into
use

If transported upright as specified, the unit can be started up immedi-
ately. If the unit was transported in another position, e.g. at an extreme
angle, wait 2 hours before connecting the unit to the power supply.
Initial startup Checking setpoint temperature of unit

The setpoint temperature used by the unit's temperature regulator is set
at the factory to +7 °C.

Change the setpoint temperature if necessary.

Subsection "Setting the setpoint temperature" on Page 14.
Connecting and switching on unit Positioning the unit

To ensure the best possible cooling of the food, note the following points
when selecting where to place the unit:

Operate the unit far away from possible heat sources (such as radia-
tors, ovens, sunlight)

Operate the unit far away from equipment which develops large
amounts of steam (e.g. dishwasher).

Ensure that the ventilation slits of the refrigeration unit are not covered by
anything (unimpeded exit of air). Ventilation slits must be at least 10 cm
from a wall with the refrigeration unit switched on.

Make sure that the condensation-water catch tray is pushed in under the
unit.

Move the unit into its designated location and lock the brakes.

Subsection "Move unit to a new location" on Page 19.

Before switching on, make sure the unit interior is in an absolutely
hygienic state.