2
Subject to change without prior notice
EN
2. Safety Information
Attention
: this symbol highlights the instructions to be followed scrupulously for the correct
functioning of the combined heat and cooling meter.
Danger
: the chapters marked with this symbol contain information that must be followed carefully
to avoid dangerous situations. Thermal energy meters are precision devices and must be protected
from shock and vibration.
Read all instructions carefully before proceeding with the installation! Failure to comply with
one or more of the procedures contained in the manual can be dangerous and cause damage to
property and people. It is recommended to comply with all applicable laws on safety and accident
prevention.
Notes
: the notes indicated by this symbol contain tips to keep in mind when using the thermal
energy meter.
The warranty and validity of the verification become void if the identification plate or the seals
applied to the instrument are removed or damaged.
Remove the device from the package only at the time of installation to protect it from damage
and dirt.
The air transport of active radio devices is prohibited.
Carefully observe the instructions in the data sheet, instruction manual, application notes and
lid. Failure to comply with the operating conditions may result in situations of danger and for-
feiture of all claims of liability for defects as well as liability based on any guarantees expressly
granted. For more information visit the website www.bmeters.com.
Dispose of replaced devices and defective components in accordance with current environmen-
tal regulations.
Store out of the reach of children.
Observe national regulations relating to the measurement of cooling.
Observe the technical requirements relating to the installation of electrical equipment.
The instrument complies with the requirements of Directive 2014/30/EU of the European Coun-
cil on electromagnetic compatibility, Directive 2014/35/EU on electrical safety and Directive
RED 2014/53/EU.
If more than one instrument is installed in a unit, the installation conditions must be the same
for all instruments to ensure that consumption is billed as possible.
