![background image](http://html1.mh-extra.com/html/b-k-lighting/precision-2-co2-series/precision-2-co2-series_installation-instructions_3111965005.webp)
12. Remove any dirt or debris in O-ring groove near
top of housing. Place O-Ring inside of groove.
Failure to clean groove of debris will cause
fixture to fail and void product warranty.
13. Install faceplate using 1/8” Allen wrench and
hand-tighten the faceplate screws in a star
pattern to 30 in-lbs. min.
Do not use a power tool to install screws. Do
not exceed 40 in-lbs.
RELEASE DATE
10-21-2019
REFERENCE
NUMBER
INS001399.1
40429 Brickyard Drive • Madera, CA 93636 • USA
559.438.5800 • FAX 559.438.5900
www.bklighting.com • [email protected]
B-K LIGHTING
IMPORTANT SAFETY INFORMATION LISTED ON REVERSE
READ, FOLLOW, AND SAVE ALL SAFETY AND INSTALLATION INSTRUCTIONS
CO
2
SERIES
Inspiration Control System
Installation Instructions
iOS device (Not Included) with installed B-K Lighting Inspiration Application required for use.
11. To aim OptiLock® vertically: loosen two (2) 1/4-20
screws using 3/16” Allen wrench. Tilt swivel arm
with LED and optic in desired aiming direction.
Tighten two (2) 1/4-20 screws with 3/16” Allen
wrench to secure position.
2. Use a Phillips screwdriver to unscrew the 2 screws
holding the reflector adapter and LED module.
Remove wire ribbon connector from LED module.
Clean all Arctic Silver Ceramique thermal grease
from heatsink.
2. Apply a thin and even coating of Arctic Silver
Ceramique thermal grease provided with
replacement LED module to the bottom of the new
LED module. Snap the wire ribbon connector to the
LED module. Place the LED module on the heatsink.
Place reflector adapter to top of LED module and
align all the screw holes together.
3. Screw down the LED module and reflector adapter.
1. To replace the LED module: Twist reflector off.
LED Replacement