Orbit Industries, Inc.
INSTALLATION INSTRUCTIONS
2100 S. Figueroa St. Los Angeles, CA 90007
Tel (213) 745-8884 Fax (213) 745-2015
www.orbitelectric.com
WARNING:
All work must be performed by qualified electrician. Luminaire must be installed and grounded in
accordance with the National Electrical Code (NEC) and local codes. Failure to do so may result in serious
injury and/or damage to the luminaire.
WARNING:
To avoid risk of fire, explosion, or electric shock, this product should be installed, inspected, and
maintained by a qualified electrician only and in accordance with all applicable codes.
WARNING:
To avoid electric shock:
Be certain electrical power is OFF before and during installation and maintenance.
Luminiare must be connected to a wiring system with an equipment grounding conductor.
WARNING:
Make sure the supply voltage is the same as the rated luminaire voltage.
Do not operate in ambient temperatures above those indicated on the luminaire nameplate.
Keep lens tighly closed when in operation.
NOTE:
Save these instructions for future reference.
100~277V
347~480V
LWP25 - SERIES
Category:
JUNCTION BOX (WALL) MOUNT:
1. Open the fixture head at least 90 degree
to loosen the two screws by screw driver.
2. Open and lift the fixture head from the junction box
from the hinge.
3. Fixture junction box has a guided pre-punch
holes. Check your wall junction box mounting
screws and knock-out the pre-punch holes
by a screw driver.
NOTE: Before punching the holes, check the
UP direction.
SCREW DRIVER
SCREWS
FIXTURE HEAD
HINGE
JUNCTION BOX
FIXTURE HEAD
FIXTURE
JUNCTION BOX
PRE-PUNCH HOLES
SCREW DRIVER
UP
4. Install the fixture junction box to the wall junction
box (3O or 4O steel boxes). Remove one screw
of the wall junction box and install the slot of
fixture junction box.
WALL JUNCTION BOX
FIXTURE JUNCTION BOX
NOTE: ABOVE PICTURE IS FOR ILLUSTRATION PURPOSES ONLY.
IT MAY DIFFER IN ACTUAL INSTALLATIONS.
5. Re-install the fixture head thru the hinge of the
fixture junction box.
HINGE
JUNCTION BOX
FIXTURE HEAD
6. Attach fixture leads to line observing polarity,
black to black, white to white and green to
ground to junction box.
7. Close the fixture and tighten the two screws.
Check GASKET if sitting properly.
For better waterproofing apply a silicone
around the fixture junction box and wall
surface.
If 1/2” threaded holes on the sides is used,
apply a silicone after installation.
8. Adjust the fixture to a proper angle.
9. Turn ON power and check for proper
operation.
NOTE: PHOTOCELL IS EITHER 120V OR 277V, BEFORE INSTALLING CHECK SUPPLY VOLTAGE.
