CO
2
SERIES
Inspiration Control System
Installation Instructions
RELEASE DATE
10-21-2019
REFERENCE
NUMBER
INS001399.1
40429 Brickyard Drive • Madera, CA 93636 • USA
559.438.5800 • FAX 559.438.5900
www.bklighting.com • [email protected]
B-K LIGHTING
IMPORTANT SAFETY INFORMATION LISTED ON REVERSE
READ, FOLLOW, AND SAVE ALL SAFETY AND INSTALLATION INSTRUCTIONS
iOS device (Not Included) with installed B-K Lighting Inspiration Application required for use.
4. Turn HydroLock®
Barrier Plate clockwise ¼” to
lock.
Patented
HydroLock® Barrier Plate must be
completely seated to ensure proper seal or
water may intrude. This step must be done
as stated or you will void your warranty.
3. Wipe inside of housing where HydroLock® plate
will sit clean of debris before inserting patented
HydroLock® plate on to junction box. Align
HydroLock® plate with pins in housing and seat
it firmly in place.
5. Connect driver assembly to Patented
HydroLock
™
Barrier plate with quick disconnect.
Number of plugs and size of plugs may vary
depending on wiring controls chosen as per
lighting plan.
6. Attach driver assembly to housing by aligning
keyhole notch under one (1) of three (3) #8 screw
heads.
7. Tighten the Phillips screws to secure driver
plate to housing.
8. Attach OptiLock® assembly to installed driver
assembly with quick disconnect. Place OptiLock®
assembly in housing, resting the OptiLock® on
the pins provided inside the housing.
10. To aim OptiLock® horizontally: lift OptiLock®
from resting position, and rotate to desired
angle. Set down on pins provided in housing.
OptiLock® is gravity held in place.
WIRING DIAGRAM - DMX
Leads are labeled. Recommended wire:
- Liberty Cable
24-2P-285 Non Plenum
24-2P-P485 Plenum
- Belden Cable
9842 Non-Plenum
89842 Plenum
Maximum of 30 fixtures per DMX runs.
Please refer to wire manufacturer’s lighting
catalog for and equals as required by code.
Hydrolo
ck Plate
Line (Black)
Neut (White)
Ground (Green)
DMX In Common (Blue)
DMX Out Data + (White)
DMX Out Data - (Black)
DMX Out Common (Green)
DMX In Data - (White)
DMX In Data (Orange/White)
9. HP2 Accy Holder Installation/Removal
For Optional Accessory Holder: Loosen the
thumbscrew and then tilt the Accessory Holder
up off the reflector so the second screw can
clear the edge of the reflector.
