RELEASE DATE
10-21-2019
REFERENCE
NUMBER
INS001399.1
40429 Brickyard Drive • Madera, CA 93636 • USA
559.438.5800 • FAX 559.438.5900
www.bklighting.com • [email protected]
B-K LIGHTING
2. Place housing in hole. Align junction box in the
path of the conduit trench.
3. Insert (4) pieces of ½” EMT conduit through the
Stability Flange™. Hammer into substrate until
secure.
Leave sufficient clearance to elevate housing
to finished grade.
4. To accommodate the overhang and allow for
proper sealing between the faceplate and
housing, you’ll need to
elevate the housing at
least a 1/4”
above the finish grade. Use a level
to aid in leveling housing.
5. When housing is level, tighten screws on
Stability Flange™ to secure housing to EMT.
Remove excess EMT as needed.
Housing Installation
Threaded Entry
Side Flats
1. Connect branch conduit connectors (By Others)
to the junction box using either the threaded
conduit entries on the bottom of the junction
box or through holes drilled into the sides of the
junction box.
6. Connect the conduit to the conduit connectors.
7. Pull primary branch circuit wiring into junction
box.
IMPORTANT SAFETY INFORMATION LISTED ON REVERSE
READ, FOLLOW, AND SAVE ALL SAFETY AND INSTALLATION INSTRUCTIONS
CO
2
SERIES
Inspiration Control System
Installation Instructions
iOS device (Not Included) with installed B-K Lighting Inspiration Application required for use.
Soil Prep
Conduit
trench
18”
Dia.
A. Determine Soil Type by referencing DIG-IT
Guide.
B. Dig hole 18” wide and 20” deep.
Conduit
Trench
Excavated
for Housing
C. Prep soil according to DIG-IT Guide.
