1
CROSSBEAM
KICKSTAND
Slip the bottom of the kickstand into the
inside of one of the crossbeams.
2
Pull kickstand completely through and ensure the
pins in the kick stand base insert into the indentions
on the inside of the Crossbeam.
3
Bring the other side of the crossbeam to
meet up against the kickstand side.
4
Compress both sides of the crossbeam and
you should feel a click as the cross beam pins
fit into the opposite side.
5
HULL PAD
Swivel the hull pad into the hook.
6
Continue to swivel the hull pad until it is flat.
The hull pads will pivot to fit your kayak hull.
7
Slip the wheel over the axle.
8
CLICK TO
LOCK
Push down on axle pin till it clicks into the lock position.
Install straps as shown on back of instructions and
you are ready to use your C-TUG.
9
