PM1RM RECTANGULAR CAMLOCK™
Recessed junction box installation
REVISION DATE
7-27-09
REFERENCE NUMBER
INS-1515B
40429 Brickyard Drive • Madera, CA 93636 • USA
559.438.5800 • FAX 559.438.5900
www.bklighting.com • [email protected]
B - K L I G H T I N G
THIS DOCUMENT CONTAINS PROPRIETARY INFORMATION OF B-K LIGHTING, INC. AND ITS RECEIPT OR POSSESSION DOES NOT CONVEY ANY RIGHTS TO REPRODUCE, DISCLOSE ITS CONTENTS, OR TO MANUFACTURE, USE OR SELL ANYTHING IT MAY DESCRIBE.
REPRODUCTION, DISCLOSURE OR USE WITHOUT SPECIFIC WRITTEN AUTHORIZATION OF B-K LIGHTING, INC. IS STRICTLY FORBIDDEN.
•
Product must be installed by a qualified person in a manner
consistent with its intended use and in compliance with the
National Electrical Code, Canadian Electrical Code, and all Local
and Provincial Codes.
•
Follow product label information and instructions.
•
Qualified Personnel must perform all servicing or relamping of
this product.
•
Before wiring to power supply and during servicing or
relamping, turn off power at fuse or circuit breaker before
service.
IMPORTANT SAFETY INFORMATION - READ, FOLLOW, AND SAVE ALL SAFETY AND INSTALLATION INSTRUCTIONS
•
The use of accessory equipment not recommended by the
manufacturer or installed contrary to instructions may cause an
unsafe condition. The use of damaged components may cause
an unsafe condition and void product warranty.
•
Do not block light emanating from product in whole or part, as
this may cause an unsafe condition.
•
Never operate the fixture with missing or damaged lens. Lens
must be cleaned on regular basis.
•
Energized lamp gets hot very quickly. Allow it to cool before
service.
•
Entire fixture may become extremely hot. Do not touch hot lens
or fixture body. Do not touch the lamp at any time. Use a clean,
dry, soft cloth to handle the lamp. Oil from skin may damage the
lamp and cause it to rupture.
•
Replace lamp only with correct wattage and type of lamp
marked on fixture label.
•
All gaskets, o-rings and sealing surfaces must be kept clean
during installation and service; failure to do this may cause an
unsafe condition and void product warranty.
A
B
C
1.
Install standard 4.5” x 2.85” recessed junction box
(by others) in the final fixture location according
to designed lighting plan.
NOTE: Vertical or horizontal installation of
recessed junction box determines orientation
of UPM.
2.
Pull branch circuit wiring necessary for
installation (By Others.)
3.
Feed branch circuit wiring and lamp leads to
remote mounted fixture through mounting plate
with CamLock™ assembly. Attach mounting plate
with supplied (2) #6-32 stainless steel hex drive
fasteners to recessed junction box using a 5/64”
allen wrench.
4.
Feed wire into UPM housing. Install housing on
CamLock™ at 90° to finished orientation as
shown. (Figure A)
5.
Rotate housing 90° counter-clockwise (Figure B).
Tighten set screw with 5/64” allen wrench on
outside of UPM housing to lock in place.
(Figure C)
Rectangular UPM mounting plate with CamLock™ assembly
UPM faceplate
Patented 1/2” NPT knockouts*
UPM housing with loose transformer
* UPM is covered in whole or in part by US patent #6,940,012
NEEDED
FOR
INSTALLATION:
By Others
Warning
High Voltage
Hot Surface
5/64” & 9/64” allen wrench
Wire connectors
Phillips screwdriver
Level
