Warning
Hot Surface
TOOLS
NEEDED:
By Others
AGI2 LED
LED Installation
1/8”, 3/16” & 0.050” Allen Wrench
Phillips Screwdriver
Small Pick Tool
RELEASED
12-19-2019
REFERENCE
NUMBER
INS-2816-00
40429 Brickyard Drive • Madera, CA 93636 • USA
559.438.5800 • FAX 559.438.5900
www.bklighting.com • [email protected]
B-K LIGHTING
THIS DOCUMENT CONTAINS PROPRIETARY INFORMATION OF B-K LIGHTING, INC. AND ITS RECEIPT OR POSSESSION DOES NOT CONVEY ANY RIGHTS TO REPRODUCE, DISCLOSE ITS CONTENTS, OR TO MANUFACTURE, USE OR SELL ANYTHING IT MAY
DESCRIBE. REPRODUCTION, DISCLOSURE OR USE WITHOUT SPECIFIC WRITTEN AUTHORIZATION OF B-K LIGHTING, INC. IS STRICTLY FORBIDDEN.
IMPORTANT SAFETY INFORMATION - READ, FOLLOW, AND SAVE THESE INSTALLATION INSTRUCTIONS
1. Remove faceplate using 1/8” Allen wrench. Remove
optional accessory holder (if applicable).
2. Turn, then lift OptiLock® from housing. Disconnect
OptiLock® assembly from driver assembly using
quick disconnect.
9. Attach OptiLock® assembly to installed driver
assembly with quick disconnect. Place OptiLock®
assembly in housing, resting the OptiLock® on the
pins provided inside the housing. Gravity will hold
OptiLock® in place.
3. Remove optic by turning to the left to unlock optic
from optic holder tabs, and lift up.
Do not pull on connector or wiring. Handle with
care.
4. Use small Phillips screwdriver to remove two (2)
#4-40 fasteners on optic holder, then remove optic
holder to expose LED module.
5. Carefully remove LED module from heatsink.
Do not pull on connector or wiring. Handle with
care.
6. Use small pick tool to push connector off LED board
through two small slots behind connector. Once
loose, lift connector upwards and off board.
8. Reverse install optic holder, and then optic.
7. Place new LED module onto heatsink. Press
connector straight downwards into slot on module
to snap into place.
Connector will only fit in one direction.