RELEASE DATE
12-19-2019
REFERENCE
NUMBER
INS-2816-00
40429 Brickyard Drive • Madera, CA 93636 • USA
559.438.5800 • FAX 559.438.5900
www.bklighting.com • [email protected]
B-K LIGHTING
AGI2 LED
IMPORTANT SAFETY INFORMATION LISTED ON REVERSE
READ, FOLLOW, AND SAVE ALL SAFETY AND INSTALLATION INSTRUCTIONS
Relamping and Optic Adjustment
10. Install faceplate using 1/8” Allen wrench and
hand-tighten the faceplate screws in a star
pattern to 30” lbs. min.
Do not use a power tool to install screws. Do
not exceed 40” lbs.
9. Remove any dirt or debris in O-ring groove near
top of housing. Place O-Ring inside of groove.
Failure to clean groove of debris will cause
fixture to fail and void product warranty.
1. Remove faceplate using 1/8” Allen wrench.
7. To aim OptiLock® horizontally: lift OptiLock®
from resting position, and rotate to desired
angle. Set down on pins provided in housing.
OptiLock® is gravity held in place.
8. To aim OptiLock® vertically: loosen two (2)
1/4-20 screws using 3/16” Allen wrench. Tilt
swivel arm with LED and optic in desired aiming
direction. Tighten two (2) 1/4-20 screws with
3/16” Allen wrench to secure position.
2. Turn, then lift OptiLock® from housing.
Disconnect OptiLock® assembly from driver
assembly using quick disconnect.
3. Remove optic by turning to the left and lifting
up. Remove the optic holder from the LED
board by loosening three (3) optic holder
fasteners using 0.050” Allen wrench.
6.
Attach OptiLock® assembly to installed
driver assembly with quick disconnect. Place
OptiLock® assembly in housing, resting the
OptiLock® on the pins provided inside the
housing. Gravity will hold OptiLock® in place.
4. Use 0.050” Allen wrench to loosen three (3) #2-56
screws on LED component. Reverse install new
LED component. Ensure LED component is firmly
seated on heatsink.
LED component can only fit
in one direction.
5. Install optic holder with three (3) optic holder
fasteners using 0.050” Allen wrench. Reverse
install optic.