ADJUSTABLE WELL STAR™
Installation Instructions
TECHNOLOGY
with
TECHNOLOGY
& Low Voltage
RELEASE DATE
9-8-15
REFERENCE
NUMBER
INS000967
40429 Brickyard Drive • Madera, CA 93636 • USA
559.438.5800 • FAX 559.438.5900
www.bklighting.com • [email protected]
B-K LIGHTING
IMPORTANT SAFETY INFORMATION LISTED ON REVERSE
READ, FOLLOW, AND SAVE ALL SAFETY AND INSTALLATION INSTRUCTIONS
Replamping for Low Voltage Halogen
2. Slide fixture body out of aiming bracket.
3. Use 9/64” Allen wrench to loosen #8-32 stainless
set screws and remove cap.
1. Remove faceplate from housing by loosening
three (3) #10-24 set screws in faceplate using a
1/8” Allen wrench.
6. Slide fixture body into aiming bracket.
7. Adjust aiming bracket by loosening two (2)
Phillips screws at sides of bracket. Adjust angle
as per lighting plan, then secure position by
tightening two (2) Phillips screws.
8. Faceplate allows full rotational positioning.
Loosen three (3) #10-24 set screws in faceplate.
Align faceplate opening to object to be
illuminated. Secure faceplate to housing by
tightening three (3) #10-24 set screws using a
1/8” Allen wrench.
4. Firmly insert lamp pins into socket to make
connection. Rocking motion may be required.
Do not exceed the maximum wattage listed on
the fixture label before installing.
5. Use 9/64” Allen wrench to tighten #8-32
stainless set screws and secure cap.
Warning: Do not over tighten set screw.
Doing so will compromise O Ring seal and
will void warranty.
