RELEASE DATE
9-8-15
REFERENCE
NUMBER
INS000967
40429 Brickyard Drive • Madera, CA 93636 • USA
559.438.5800 • FAX 559.438.5900
www.bklighting.com • [email protected]
B-K LIGHTING
IMPORTANT SAFETY INFORMATION LISTED ON REVERSE
READ, FOLLOW, AND SAVE ALL SAFETY AND INSTALLATION INSTRUCTIONS
ADJUSTABLE WELL STAR™
Installation Instructions
TECHNOLOGY
with
TECHNOLOGY
& Low Voltage
2. Slide fixture body out of aiming bracket.
3. Use 9/64” Allen wrench to loosen #8-32 stainless
set screws and remove cap.
Replacing LED & Optics
1. Remove faceplate from housing by loosening
three (3) #10-24 set screws using a 1/8” Allen
wrench.
4. Space three fingers evenly around the optic
and gently rock optic to remove.
5. Use 5/64” Allen wrench to remove two (2)
#2-56 socket head cap screws on LED board,
grasp LED board and gently pull up to expose
quick disconnect.
6. Disengage LED board and driver assembly.
Replace with new board and driver assembly.
7. Reverse install LED board and driver by
carefully engaging quick disconnects and
inserting into fixture body. Secure LED board
in place with stainless steel screws. Snap optics
in place.
8. With flat head screw driver rotate dial to
desired lumen output. Replace cap.
9. Use 9/64” Allen wrench with #8-32 stainless set
screws to secure cap.
11. Slide fixture body into aiming bracket.
10. Adjust aiming bracket by loosening two (2)
Phillips screws at sides of bracket. Adjust angle
as per lighting plan, then secure position by
tightening two (2) Phillips screws.
12. Faceplate allows full rotational positioning.
Loosen three (3) #10-24 set screws in faceplate.
Align faceplate opening to object to be
illuminated. secure faceplate to housing by
tightening three (3) #10-24 set screws using a
1/8” Allen wrench.
