LK-IP/KNXs
REG
Operating Manual
17
LK-IP/KNXs REG
90403
6.4.2
Interface settings within ETS
Within the ETS, KNX interfaces can be selected and set up via the ETS menu "Bus –> Interfaces".
The ETS can access configured KNX IP routers even without a database entry. If the setup of the
KNX IP router does not comply with the conditions of the KNX installation it must be configured via
an ETS project. See section "ETS product database" on page 19 for more information.
As factory default the assignment of the IP address is set to “automatically via DHCP” and thus no
further settings are necessary. To use this feature a DHCP server on the LAN must exist (e.g. many
DSL routers have an integrated DHCP server).
After connecting the KNX IP router to the LAN and the KNX bus, it should automatically appear in
the ETS within the menu "Bus" under "Discovered interfaces".
By clicking on the discovered interface it is selected as the current interface. On the right side of the
ETS window all specific information and options of the connection appear.
The indicated device name and the "Host Individual Address" (individual address of the device) can
be changed within your ETS project then.
INFO
Due to the significantly shorter transmission times, it is recommended to perform down
-
loads via IP.
