S T O R A G E
WP-1924
Pour-Through Water Purification and Filtration System
6
To store for brief periods of non-use (several days), flush the system throughly (at least 2 gallons) before
and after the period of non-use.
If you are not planning to use the system for an extended period of time (several weeks, months or more)
the Pleated Fibrous Filter and Multi-Media Cartridge must be replaced before re-using the system.
1.
Run clear water through the system to flush the cartridges.
2.
Remove the Filter Cartridges from Filter Connector and allow them to drain and dry. The Pre-Filter Net
and Filter Sleeve should also be dry before storage.
3.
Rinse and wipe the system out according to the maintenance instructions on the previous page and
wipe dry with a clean soft cloth. Remember to wipe the outside of the source water container as well.
Note:
As you un-assemble unit remember to place all cleaned components and filters on a clean
surface to avoid contamination.
4.
Remove Spigot and associated washers and nuts.
5.
Replace the sanitary caps in the holes left by the Filter Connector
and the Spigot.
6.
Place the Spigot and Spigot parts, Gaskets and Filter Connecter in
a re-sealable plastic parts bag.
7.
Place the Pre-Filter Net, Filtration Sleeve, Multi- Media Cartridge,
the Pleated Fibrous Filter and the bag containing the Spigot,
Gaskets and Filter Connector into the Source Water Container.
8.
Place the lid on the Source Water Container and, after wiping down
the outside, place it inside the Purified Water Container.
9.
Place the lid back onto the Purified Water Container to
protect contents from contamination.
10.
Place the system in its box.
This system is now fully un-assembled and ready for storage or transport.
Remember: After storage or transport clean the spigot and the interior of the purified water container before using
it. Moisture from the sediment pre-filter and/or the source water container can contaminate it when In the “stored”
position.
