Bischoff & Bischoff GmbH | 01.06.2019
EN
57
56
Taiga
| Electric Wheelchair
Electric Wheelchair |
Taiga
3.5.2 Electronic footrests
Length of lower leg supports
•
The lower leg supports can be adjusted from 420 - 580 mm.
•
To do so, loosen the two allen screws.
•
Adjust to the desired height (fig. 05).
•
Tighten the screws again.
•
Use medium-strength Loctite to lock screws in place.
Angle of footrest
•
The angle of the footplate is fully adjustable.
•
Undo the screw to the side of the footplate.
•
Adjust the footplate to the desired angle (fig. 06).
•
Tighten the screw again.
•
Use medium-strength Loctite for fixation.
Height of the calf pad
•
The height of the calf pad is adjustable.
•
Undo the screw to the side of the footrest.
•
Adjust the calf pad to the desired height (fig. 07).
•
Use medium-strength Loctite for fixation.
05
06
07
3.5.3. Seat
Seat with (mechanical)
•
The seat with can be adjusted in three steps from 415 mm to 515
mm.
•
Ensure that the wheelchair is switched off.
•
Remove the attachment parts such as the leg rests, side parts, back
pad and seat pad.
•
Detach the Velcro straps of the back rest cover (mechanically).
•
You first adjust one half of the seat (left or right) and then the
other
•
For each side, you must loosen two fastening screws under the seat
(fig. 08) and remove two Allen head screws from the back rest (fig.
09).
•
Move the seat half to the desired width. Markings on the seat (fig.
10) serve as orientation aids. Shift the seat and back rest equally.
•
Secure the screws to the back rest and tighten them and the
fastening screws under the seat. Repeat the procedure with the
other half of the seat
•
You can pull the Velcro straps of the back rest taut again and
reattach all other attachment parts.
08
09
Ensure that both halves of the seat are adjusted
equally.
10
Make sure there is an appropriate distance between
footrests and the ground.
