Aztech VC3000, User Manual

Page: 16 / 20

16
You may strip out the ONE FIT ALL brush
from the roller for deeper cleaning or
component replacement. 5.
NOTE: In replacing the ONE FIT ALL brush,
ensure to ONLY use genuine Aztech
products.
Install the right side of the roller brush into
the vacuum cleaner’s drive shaft. The
semi-circular hole of the roller brush must
align to the semi-circle figure of the drive
shaft. You may have to rotate the roller
brush to align these.
6.
Ensure that the roller brush is properly
lodged in and installed. The soft semi-
circular rubber cap of the brush must be
flatly positioned on the vacuum cleaner.
7.
Align the buckles of the cleaning bracket
to the two (2) U-shaped grooves on the
surface of the vacuum cleaner and press
down to lock.
8.
Remove the brush’ tube fixing member
and rubber cap on both sides of the
roller brush and remove the hair knotted
around the brush tube fixing member.
4.
Pull up the left side of the brush and slowly
lift out the roller brush to completely
remove the component from the
vacuum cleaner. 2.
You may wash the brush with water as
needed. Ensure to completely dry the
cleaning component afterwards. 3.
PULL oUt BRUSh
WASh AND DRY
thE BRUSh
REMoVE AND
CLEAN BRUSh
fiX
StRiP oNE fit
ALL BRUSh
oPtioN:
iNStALL RoLLER
BRUSh
LoCK PRoPERLY
iNto PLACE
ALiGN CLEANiNG
BRACKEt BUCKLES