PROSCRUB OWNER’S MANUAL PAGE
7
08-2017
DRAINING AND FILLING THE TANKS
Use only nonflammable chemicals. Damage or personal injury may occur.
Use only non-
foaming detergents and dilute according to the manufacturer’s
instructions. If using powdered cleaners, dissolve thoroughly before adding to solution tank.
The Recovery Tank must be drained every time before refilling the solution tank.
If it is not drained before solution tank is refilled, foam or water will enter the vacuum standpipe and
damage will occur. This damage is not covered by warranty.
Do not fill with boiling water. Temperature must not exceed 140 F. Damage will
occur to the tanks. This damage is not covered by warranty.
Rinse and flush solution tank thoroughly with clean water after each use. This will
prevent chemical buildup. This will prevent odors or mildew from forming.
Before filling or draining either tank, make sure all
switches are at the “OFF”
position.
When moving the scrubber to either fill or drain, make sure brushes and
squeegee are in the “UP” position.
DRAINING THE PROSCRUB RECOVERY TANK:
1.) Make sure
Solution Control Knob
is completely turned to OFF position
2.) Remove black recovery tank lid
3.) Remove Black Drain Hose from holder; place hose end over a drain and unscrew cap to start flow
4.) When recovery tank is almost empty, lift lid like you would to examine batteries and hold lid
diagonally to fully drain
5.) Close tank
6.) Unscrew lid on recovery tank and use hose to rinse out tank
7.) Screw cap back on
Black Drain Hose
and replace drain hose securely
