Azkoyen t3 hopper, Manual

Page: 7 / 48

7
07 - 2009
diameters and thicknesses of the coins. For the Euro currency there is one unique
configuration that covers the whole range of coins, except the one cent coin.
5)
If the machine is fitted with a base plate for the hopper, place the hopper on the
base so that the gaps coincide with the tabs on the T3, then slide the hopper firmly
into the base until you hear the clips activate.
6)
Although it is recommended to always use the base plate for correct fixture and
connection, in the case that the machine does not have one, use the fixtures in the
machine to install the hopper. Special care should be taken with the connector to
make the connections physically coincide.
7)
If the T3 is a ccTalk
®
model
, it will be necessary to configure the address of the
hopper within the system. For this, three different methods may be used to configure
the hopper addresses:
i. Hardware configuration, by means of the three addressing lines present at the
main connector. By default, the hopper is assigned inside the ccTalk bus with
the address number 3. When more than one hopper is used it is needed the
assignation of addresses for the rest of devices connecting one or more selection
lines to the positive connVs.
Pinout ccTalk connector
Pin Function
1 0V (GND)
2 NC
3 NC
4 Sel. Adr.1 (LSB)
5 DATA (Cctalk)
6 NC
7 NC
8 Sel. Adr.2
9 +Vs (+24V)
10 NC
11 NC
12 Sel. Adr.3 ( MSB)