30
■
Other indications
●
Instantaneous flow rate peak value
(1) Press and hold
[
]
for 2 seconds or more in the normal indication mode.
>> The
MCF
moves to instantaneous flow rate peak value display mode, and
indicates “
FlOHI
” and the peak value alternately.
(2) To quit instantaneous flow rate peak value display mode, push the
[mode]
key.
>> The
MCF
returns to normal indication mode.
• To clear the instantaneous flow rate peak value, press and hold
[
]
for 5 sec-
onds or more while the peak value is displayed.
●
Instantaneous flow rate lowest value
(1) Press and hold
[
]
for 2 seconds or more in the normal indication mode.
>> The
MCF
moves to instantaneous flow rate lowest value display mode, and
indicates “
FlOLO
” and the lowest value alternately.
(2) To quit instantaneous flow rate lowest value display mode, push the
[mode]
key.
>> The
MCF
returns to normal indication mode.
• To clear the instantaneous flow rate lowest value, push and hold [
]
for 5 sec-
onds or more while the lowest value is displayed.
■
Resetting integrated data
To reset integrated data, press and hold
[
]
and
[
]
at the same time for 5 sec-
onds or more while the first or last part of the integrated flow amount is indicated
on the display.
The integrated flow is reset to zero, unless integrated flow countdown has been
selected. In that case, the integrated flow is reset to the amount set in the integrated
flow event setup (
EI.HI
and
EI.LO
).
■
Maintenance mode
The
MCF
has a special maintenance mode for transferring adjusted values before
swapping the measurement module, adjusting the output circuit, etc.
●
Changing the Maintenance mode settings
(1) Press and hold the
[mode]
key for 2 seconds or more in the normal indication
mode. Then press and hold the
[mode]
key and
[
]
key at the same time for 2
seconds.
(2) Move to the desired setup item with the
[
]
or
[
]
key, and then press
[enter]
.
>> The current setting is shown with the rightmost digit blinking.
(3) If the
[mode]
key is pressed, the left digit blinks.
Blinking
Blinking
[mode] key
Chapter 5. SETTING AND OPERATION
