Azbil CMG Series, User Manual

Page: 9 / 34

บริษัท เอดีดี เฟอร์เนส จ ำกัด
ADD FURNACE CO.,LTD.
44 ซอยบรมราชชนนี 70 ถนนบรมรำชชนนี แขวงศำลำธรรมสพน์ เขตทวีวัฒนำ กรุงเทพฯ 10170
โทร
: 02-888-3472
โทร
:
ออกแบ
บ
:
08-08-170-170
แฟกซ์
: 02-888-3258
https://www.add-furnace.com E-mail: sales@add-furnace.com
Fuse
M3.5 (6) terminal screws
EVENT2 4
Chapter 2. NAMES AND FUNCTIONS OF PARTS
Lo indicator:
Blinks when the lower limit alarm occurs.
Hi indicator:
Blinks when the upper limit alarm occurs.
OVER indicator:
Lights when the flow rate exceeds the
measurement range. Blinks when
the integration event occurs.
CF indicator:
Lights during integrated flow rate display.
Goes out during total flow rate display.
Blinks once at each pulse output.
CFH indicator:
Lights during instantaneous flow rate
Alarm indicator:
Blinks when an alarm occurs.
Display:
Displays the instantaneous flow rate value,
integrated flow rate value, total flow rate
value, function setting values and parameter
setting values on a in 7-segment LED
display.
RESET key:
Use this key to reset alarms/integrated flow rate.
/ ALARM
RESET ENT
display.
DISP key:
Use this key to switch between
instantaneous flow rate display and
integrated flow rate display, and from
setup mode to instantaneous flow rate
display.
key:
Use this key to increment a value.
key:
Use this key to decrement a value.
Also use it to switch to the function
setup mode.
key:
Use this key to feed digits when changing setting
values. Also use it to move to the parameter
setup mode.
Operation unit cover:
Open this cover to configure or reset
various settings.
Wiring hole:
There are two wiring holes.
Insert the plug and seal packing
(provided) in the unused hole
Outlet:
This is where the fluid
to be measured flows out.
Operation panel:
Use this panel to set functions,
parameters, alarms or alarm occurrence
wait time, and to reset alarms or reset
the integrated flow rate.
ENT key:
Use this key to fix and store settings to
memory. Also use it to display total
flow rate, or to switch to the function
setup mode.
Sensor/terminal section:
Houses the Micro Flow sensor chip
amplifier and wiring terminal plates.
Inlet:
This is where the fluid to be measured
flows in.
Flow path:
The fluid to be measured flows
through the flow rate.
Fuse position
3