9
AB-7333
Installation
WARNING
Electric shock
Install this product in a location out of reach of unauthorized people. (e.g. Inside of the control panel with
a lock)
Failure to do so might cause electric shock.
CAUTION
General
Do not drop this product.
Doing so may cause an injury or may damage the device.
General
Install, wire, and use this product under the conditions specified by this manual.
Failure to do so may cause fire or device failure.
General
Installation and wiring must be performed by personnel qualified to do instrumentation and electrical
work.
Mistakes in installation or wiring may cause fire or electric shock.
z
Installation Location
This product must be installed in a control panel cabinet.
Note: A unit that satisfies the following conditions is considered to be equivalent to a control panel.
Flame resistance: V-1 or higher (UL 94 standard)
Strength: Enclosure stiffness test (EN 61010-1:2010 8.2)
The control panel should be installed in a place that satisfies the following:
•
An indoor place that is not exposed to direct sunlight
•
A place that is not near water
Note: The product is not waterproof.
z
Installation Angle
•
This product should be installed upright in the control panel.
Installation of this product on a slant or laid on its side is prohibited. Doing so reduces heat radiation performance, which
may cause the internal temperature to rise abnormally.
Figure 4. Installation angle
•
Do not block the ventilation holes by putting an object on top of the product, etc.
Install vertically
Front
Side
