13
AB-7333
(4) Insert the cable whose wire was exposed in step (1)
into the cable clamp and tighten it by turning the
screw above the cable clamp to the right with a
screwdriver.
The screw tightening torque is 0.5 N·m–0.6 N·m.
Make sure there are no strands of cable wire
protruding from the cable clamp.
Note: Check that the cable is inserted into the cable jack.
(5) Lightly pull the cable to check that it does not come
out.
(6) Insert the connector into the device.
Check that the release levers of the connector are
securely locked.
(7) Lightly pull the cable to check that the power supply
connector does not come out.
<Power Supply Terminal Block>
Terminal No.
Description
1
AC input
2
AC input
3
Ground
Do not insert
the cable here.
Cable clamp
(opening)
z
Wiring of the Direct Input Terminal Blocks and
Direct Output Terminal Block
Terminal Nos.
4 to 11
Terminal Nos.
12 to 19
Direct input
(DI) terminal
block
Terminal block
(not used)
Terminal Nos. 24 to 27
Direct output (DO)
terminal block
Terminal Nos. 20 to 23
(1) Strip 7 mm of insulation from the cable core wire.
(2) If the connector is plugged into the device, push in
the release levers on the right and left sides of the
connector to remove it from the device.
(3) Turn the screw above the cable clamp (the hole for
the cable) of the connector to the left with a screw-
driver to open the cable clamp.
(4) Insert the cable whose wire was stripped in step
(1) into the cable clamp and tighten it by turning
the screw above the cable clamp to the right with a
screwdriver.
Make sure there are no strands of cable wire
protruding from the cable clamp.
(5) Lightly pull the cable to check that it does not come
out.
(6) Insert the connector into the device.
Check that the release levers of the connector are
securely locked.
(7) Lightly pull the cable to check that the power supply
connector does not come out.
Push in
