Section 9 - 2
Azalea Aviation Copyright 2014
Valve cover set
Inspect all parts for condition and quality.
Apply oil to the ends and sides of the pushrods and install into the guide plates
until seated fully into the lifters. Apply oil to the guide plate where the pushrod
makes contact. Make sure the end of the pushrod with the small hole on the side is
toward the heads and away from the lifter. This hole squirts oil onto the rocker
assembly. (Fig 1)
Apply oil to the grooved ball and to the rocker. Assemble the rocker, grooved ball
and nut as shown and install. ( Fig 2) Tighten only until the end of the nut is even
with the rocker shaft. Proceed will all twelve assemblies.
