17
OFF
：
(De-activate WDMX)
In this status
，
wireless system is not activated
，
so the fixture can not log in the transmitter.
REST
：
(reset WDMX memory)
Can remove the fixture from the connection with the transmitter
，
the fixture become free and
ready to log in any transmitter.
9.4
Setup the wireless system
：
1)
Connect the transmitter with the DMX controller.
2)
To make the fixture installed with wireless receiver log in to the transmitter.
a)
Initially
，
the indicator on the receiver fixture should be in Solid red.
b)
Press and hold the configuration button on transmitter for less than 3 seconds the
red/green LEDs on the transmitter and the receiver fixture will flash rapidly for about
5~ 10 seconds while the system goes through its setup procedure.
c)
Once the receiver fixture is logged in to the transmitter (T1)
，
the fixture with wireless
receiver will keep the memory
，
even if restart the power
，
this unit will log in the
transmitter (T1) automatically.
3)
Use the DMX 512 to control the fixture
9.5
Remove the receivers from transmitter (T1) and to log in to another transmitter (T2)
：
Case 1
：
Remove a receiver
：
a)
On the control board of the fixture
，
enter menu to activated the function of REST
；
b)
The LED for wireless on the fixture should turn to Solid red; the receiver can log out from
the transmitter (T1)
；
c)
press the configuration button on transmitter (T2) for less than 3 second
，
then the fixture
will start to connect with the transmitter (T2).
Case 2
：
Remove all receivers from a transmitter (T1) to log in to T2
：
a)
Press and hold the configuration button on the T1 as least 5 seconds
，
can clear the
connection with all the fixtures
；
b)
All the red/green LEDs on the receiver fixtures will turn to Solid red to indicate that the
receivers are unassigned and removed from the transmitter (T1)
；
c)
Press and hold the configuration button on the T2 less then less than 3 second
，
the fixtures
will connect with the T2.
PS
：
1.
Please log the receivers out from the transmitter after every job
，
so that the receivers are in
free un assigned state and ready to be assigned to a transmitter.
2.
Do not connect the fixture which is under the communication of wireless system to the
DMX controller
，
otherwise it will cause interference from the DMX controller.
Summary of Contents for COBRA ULTRA BEAM
