Programming and editing
Record enable
To enter the PROGRAM mode of this device, follow the described steps:
1. Hold the RECORD button and press Flash buttons 1-5-6-8 in this order.
2. Release the RECORD button. The RECORD LED will light up.
Create a program
A program in this lighting controller can be a static program (one scene) or a combination of several scenes,
looped in a particular order (chase). Both scenes and chases can be activated by using the corresponding
faders in playback mode.
1. Enable the RECORD mode (see above)
2. Select the 1-24 Single mode by tapping the Mode Select button. This will give control over channel 1-24.
3. Compose a certain scene by moving the faders in the proper position until you are satisfied
4. Press RECORD to save this scene into the temporary memory
While creating a chase:
5. Repeat steps 2-4 until you have your desired scene(s)
6. Adjust the Speed and Fade time, to determine the step speed and value changing speed. This can
optionally be overridden during playback mode.
7. Select a Scene Master to store your scene. Tap the Page button to select a page 1-4
8. Press and hold the RECORD button and tap the Flash button for the scene you wish to save your program
to. All LEDs will flash, indicating that the scene has been programmed to the permanent memory.
9. You are able to continu programming, or exit the Record mode. To exit, press and hold the RECORD
button and tap the Exit button. Release the Record button.
Edit enable
1. Enable the RECORD mode (see above)
2. Use the Page button to select the page where the program that you wish to edit, is located
3. Tap the Mode Select button to select Chase..Scenes.
4. Press and hold the Edit button and tap the Flash button (13-24) of the Scene you wish to edit
5. Release the Edit button. The relevant Scene LED should light, indication that you are in Edit mode.
Note:
When the EDIT mode is entered properly, the display will show a ‘EDITING’ message.
Erase a program
1. Enable the RECORD mode (see above)
2. Use the Page button to select the page where the program you wish to delete,, is located
3. Press and hold Record button and tap the Flash button (13-24) twice, of the scene you wish to erase
4. Release the Record button and all LEDs should be lit to indicate that the program is erased
Erase all scenes/programs
1. Enable the RECORD mode (see above)
2. Press and hold Record button
3. While holding the Record button, tap the following Flash buttons in this order: 1-3-2-3.
4. Release the Record button.
5. All LEDs should be lit, indicating that all programs have been deleted.
WARNING: This function will reset the controller to its factory default settings!
Note: You must be in the Record mode to reset the controller. Check the Record LED indicator.
Record Clear
This function is used to clear the temporary memory, which contains recent made scenes/positions.
1. Enable the RECORD mode (see above).
Any information and illustrations shown in this user manual are subject to change without further notice.
User manual version: 2.0
Creation date + author initials: 29-03-2014 RV Revision date + author initials: 29-03-2014 RV