of your DMX chain.
Signal loss or distortion in DMX
values
Insert a DMX booster in your DMX
chain after 32 fixtures or fewer.
After a maximum of 32 fixtures the
DMX signal needs to be refreshed.
The fixture does not respond to all
DMX channels
Wrong DMX channel mode
Check the DMX channel mode of
the fixture. If the wrong value is
set, change the channel mode to a
different setting and try again.
I cannot switch operating modes
Fixture set to slave mode
Access the menu and adjust the
Master/Slave function to Master, if
it is set to Slave 1 or 2. During
operation as Slave, it is not
possible to activate the automatic
or music-controlled modes.
Remote control does not work
Aimed wrong
The IR receiver of the device is
placed on the front panel of the
device. If something blocks its path
or if the remote is not directly
aimed at the IR receiver, the
commands cannot be sent to the
device.
Battery empty
Check the remote battery and
replace it if necessary.
DMX mode activated on the device If the DMX mode is activated on
the device and a DMX signal is
detected, this mode cannot be
overruled by the remote.
All information and illustrations shown in this user manual are subject to change without further notice.
User manual version: 1.0
Creation date + author initials: 04-11-2015 RV Revision date + author initials: