background image

AX-HYKIA1-SWC

I N S TA L L AT I O N I N S T R U C T I O N S

AxxessInterfaces.com 

© COPYRIGHT 2021 METRA ELECTRONICS CORPORATION 

REV. 9/17/21 INSTAX-HYKIA1-SWC

ATTENTION: With the key out of the ignition, 

disconnect the negative battery terminal 

before installing this product. Ensure that all 

installation connections are secure before 

cycling the ignition to test this product.

NOTE: Refer to the instructions included with 

the aftermarket radio.

TOOLS REQUIRED

• Crimping tool and connectors, or solder gun, solder, 
and heat shrink • Tape • Wire cutter • Zip ties

TABLE OF CONTENTS

Connections ........................................................ 2-4
Installation .............................................................5
Programming .........................................................6
Steering Wheel Control Settings ...................... 7-9
   L.E.D. feedback ....................................................5
   Changing radio type ...........................................7
   Remapping .......................................................7-8
   Dual assignment .............................................8-9
Troubleshooting .....................................................9

Hyundai/Kia 

Data Interface with SWC

 

2010-2016

APPLICATIONS

INTERFACE FEATURES

•  Provides NAV outputs (parking brake, reverse, speed sense)
•  Retains audio controls on the steering wheel
•  Retains BlueLink
•  Designed for amplified* and non-amplified models**
•  Retains balance and fade†
•  Micro-B USB updatable

HYUNDAI

Elantra * 

2011-2016

Genesis Coupe * 

2013-2016

Santa Fe * 

2013-2016

Santa Fe Sport * 

2014-2016

Sonata * 

2011-2016

Sonata Hybrid * 

2011-2015

Tucson * 

2010-2015

KIA

Optima * 

2011-2015

Optima Hybrid * 

2011-2016

Sorento (with UVO) *  2011-2013

Sorento * 

2014-2016

Soul * 

2012-2013

Sportage 

2011-2016

INTERFACE COMPONENTS

•  AX-HYKIA1-SWC interface
•  AX-HYKIA1-SWC harness
•  16-pin harness with stripped leads
•  Female 3.5mm connector with stripped leads

* Requires the AX-HYKIA-SPDIF (sold separately) 
** Bristol Audio Systems not covered
† Non-amplified models only

* Without NAV

Visit 

AxxessInterfaces.com

 for more detailed information about the product and up-to-date 

vehicle specific applications

Summary of Contents for AX-HYKIA1-SWC













Reviews: