4
CONNECTIONS TO BE MADE
Attention!
This interface will work with models that are either non-amplified, or amplified.
Please follow the instructions carefully for your model vehicle. Failure to do so will result in
either no sound, or low sound. If you are unsure if your vehicle is factory amplified or not, please
contact your local dealership.
For models
with
a Sony/THX amplifier:
From the 16-pin harness with stripped leads to the aftermarket radio (harness included with interface):
• Connect the
Red
wire to the accessory wire.
Note:
If installing either an ASWC-1 or AX-LCD (both sold separately), connect the (2)
Red
wires on the AX-ADFD01 harness as well.
• Connect the
Blue/White
wire to the amp turn on wire. This wire must be connected to
hear sound from the factory amplifier.
Note:
If the vehicle is equipped with NAV, there will be an amp turn-on wire on the AX-
ADFD01 harness to connect as well.
• If the aftermarket radio has an illumination wire, connect the
Orange/White
wire to it.
• If the aftermarket radio has a mute wire and the vehicle is equipped with SYNC, connect
the
Brown
wire to it. If the mute wire is not connected, the radio will turn off when SYNC
is activated.
• Connect the
Gray
wire to the right front positive speaker output.
• Connect the
Gray/Black
wire to the right front negative speaker output.
• Connect the
White
wire to the left front positive speaker output.
• Connect the
White/Black
wire to the left front negative speaker output.
• Connect the
Green
wire to the left rear positive speaker output.
• Connect the
Green/Black
wire to the left rear negative speaker output.
• Connect the
Purple
wire to the right rear positive speaker output.
• Connect the
Purple/Black
wire to the right rear negative output.
The following (3) wires are only for multimedia/navigation radios that require these wires.
• Connect the
Blue/Pink
wire to the VSS/speed sense wire.
• Connect the
Green/Purple
wire to the reverse wire.
• Connect the
Light Green
wire to the parking brake wire
From the AX-ADFD01 harness to the aftermarket radio:
• Connect the
Black
wire to the ground wire.
• Connect the
Yellow
wire to the battery wire.
• If installing either an ASWC-1 or AX-LCD (both sold separately), connect the (2)
Red
wires
to accessory power.
• Connect the
Blue
wire to the power antenna wire.
•
For NAV models only:
Connect the
Blue/White
wire with a red connector to the amp turn
on wire. This wire must be connected to hear sound from the factory amplifier.
• If the vehicle is equipped with satellite radio or SYNC, and desired to be retained, connect
the
Red
and
White
RCA jacks labeled “RSE/SYNC/SAT” to the audio AUX-IN jacks.
Note:
Most Ford radios have satellite radio built into the radio, so this feature is lost if so.
Continued on the next page
